10. PROGRAMMING PROCEDURES
10.13 CMT/PL-3
10-22
■ Table 4: Transmission Item List
ITEM # Title on the Display Contents of Transmission CMT PL-3
2 VERIFY PLU & ING. = CMT 2 COMPARE PLU & ING. IN OLD FORMAT ○ ○
3 READ PLU & ING. FM CMT 3 READ PLU & ING. IN OLD FORMAT ○ ○
4 WRITE PLU TO CMT 4 SAVE PLU IN NEW FORMAT ○ ○
5 VERIFY PLU = CMT 5 COMPARE PLU IN NEW FORMAT ○ ○
6 READ PLU FROM CMT 6 READ PLU IN NEW FORMAT ○ ○
7 WRITE ING. TO CMT 7 SAVE ING. IN NEW FORMAT × ○
8 VERIFY ING. = CMT 8 COMPARE ING. IN NEW FORMAT × ○
9 READ ING. FROM CMT 9 READ ING. IN NEW FORMAT × ○
10 WRITE NUTRI. TO CMT 10 SAVE NUTRITION IN NEW FORMAT ○ ○
11 VERIFY NUTRI. = CMT 11 COMPARE NUTRITION IN NEW FORMAT ○ ○
12 READ NUTRI. FM CMT 12 READ NUTRITION IN NEW FORMAT ○ ○
13 WRITE SPEED KEY 13 SAVE SPEED KEY IN NEW FORMAT ○ ○
14 VERIFY SPEED KEY 14 COMPARE SPEED KEY IN NEW FORMAT ○ ○
15 READ SPEED KEY 15 READ SPEED KEY IN NEW FORMAT ○ ○
NOTE: When the PL-3 is required, FDK varies depending on the volume of ING. data.
Be careful of the following when changing a FDK.
a: During the write operation, replace the FDK with a formatted one.
b: Verify and read data in the same order as the write.
To cancel to change a FDK, press the key.
CLEAR
○: operable, ×: inoperable
To Next Page
