2.12 Bluetooth Troubleshooting 2 Troubleshooting Procedures
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 2-63
2.12 Bluetooth Troubleshooting
This section describes how to determine if the computer’s Bluetooth is functioning properly.
Perform the steps below starting with Procedure 1 and continuing with the other procedures
as required.
Procedure 1: Transmitting-Receiving Check
Procedure 2: Connection Check
Procedure 3: Replacement Check
Procedure 1 Transmitting-Receiving Check
Make sure the wireless switch on the left side of the computer is turned “On”. If it is not,
slide the switch toward the back of the computer to turn it on.
Check 1 Execute Bluetooth test program. Perform the test following the instructions
described in Chapter 3, Bluetooth Test Program. You will need a second
computer that can communicate by the Bluetooth.
If the computer passes the test, the function is correctly working. If the computer
does not pass the test, perform Procedure 2.
To Next Page
Loading...
