4.9 Wireless LAN card 4 Replacement Procedures
4 Replacement es
4.9 Wireless LAN card
Procedur
Removing the Wireless LAN card
To remove the wireless LAN card, follow the steps below and refer to Figure 4-14.
1. Disconnect the wireless LAN antenna cables (black and white) from the wireless
LAN card using an antenna coaxial cable disconnector.
2. Remove the following screw and wireless LAN card cover.
• M2×4B BIND or Security torx screw ×1
3. Remove the following screw securing the wireless LAN card.
• M2×3C BIND screw ×1
4. With grasping both the sides, disconnect the wireless LAN card from the connector
CN2600 on the system board.
CAUTION: Do not touch the connectors on the wireless LAN card and computer. When
the foreign body adheres to the connector, it might cause the breakdown.
Security torx or M2x4B BIND
Wireless LAN antenna cable
Wireless LAN card
M2x3C BIND
CN2600
Wireless LAN card cover
Hook
Figure 4-14 Removing the wireless LAN card
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-25
To Next Page
Loading...
