4.20 System board 4 Replacement Procedures
4.20 System board
Removing the System board
To remove the system board, follow the steps below and refer to Figure 4-29.
1. Remove the insulator securing the HDD cable.
2. Remove the following screws and system board. Remove the small arrow portion in
the figure below first.
• M2.5×6C Tapping screw ×2
CAUTION: When removing the system board, do not touch the PC card slot.
System board
M2.5×6C Tapping
Insulator
M2.5×6C Tapping
Wireless communication switch
Figure 4-29 Removing the system board
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-47
To Next Page
Loading...
