4.27 Display rear cover 4 Replacement Procedures
4.27 Display rear cover
Removing the Display rear cover
To remove the display rear cover, follow the steps below and refer to Figure 4-42.
1. Remove the following screws.
• M2.5×6C Tapping screw ×2
• M2.5×4B FLAT HEAD screw ×4
2. Pass the wireless LAN antenna cables and Bluetooth antenna cable through the
hole of the cover assembly and separate the display rear cover and cover assembly.
M2.5×6C Tapping
M2.5×6C Tapping
M2.5×4B FLAT HEAD
M2.5×4B FLAT HEAD
Display rear cover
Cover assembly
Figure 4-42 Removing the display rear cover
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-63
To Next Page
Loading...
