4.15 Bluetooth module 4 Replacement Procedures
4.15 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below and refer to Figure 4-24.
1. Turn over the cover assembly and disconnect the Bluetooth antenna cable from the
Bluetooth module.
2. Push the hook in the direction in the following figure to unlatch from the back of the
cover assembly and remove the Bluetooth module from the slot.
3. Disconnect the Bluetooth cable from the connector on the Bluetooth module.
Bluetooth cable
Bluetooth module
Bluetooth antenna cable
Hook
Figure4-24 Removing the Bluetooth module
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-39
To Next Page
Loading...
