4.16 Serial/S-Video board 4 Replacement Procedures
4.16 Serial/S-Video board
Removing the Serial/S-Video board
To remove the serial/s-video board, follow the steps below and refer to Figure 4-25.
1. Remove the following screw and serial/s-video board.
• M2.5×6C Tapping screw ×1
2. Disconnect the serial/s-video board cable from the connector CN9600 on the system
board and CN9610 on the serial/s-video board.
Serial/s-video board
CN9600
(on the back of the system board)
CN9610
(on the back of the Serial/s-video board)
M2.5×6C Tapping
Serial/s-video board cable
Figure 4-25 Removing the serial/s-video board
Installing the Serial/S-Video board
To install the serial/s-video board, follow the steps below and refer to Figure 4-25.
1. Connect the serial/s-video board cable to the connector CN9600 on the system
board and CN9610 on the serial/s-video board.
2. Install the serial/s-video board to the slot of the base assembly and secure it with the
following screw.
• M2.5×6C Tapping screw ×1
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-41
To Next Page
Loading...
