4.19 Fan 4 Replacement Procedures
4.19 Fan
Removing the Fan
To remove the fan, follow the steps below and refer to Figure 4-28.
1. Remove the glass tape and disconnect the fan cable from the connector CN8771 on
the system board.
2. Remove the following screws and fan from the slot.
• M2.5×6C Tapping screw ×2
M2.5×6C Tapping
Glass tape
Fan cable
CN8771
Fan
Figure 4-28 Removing the fan
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-45
To Next Page
Loading...
