4 Replacement Procedures 4.27 Display rear cover
4-64 [CONFIDENTIAL] TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
Installing the Display rear cover
To install the display rear cover, follow the steps below and refer to Figure 4-42.
1. Install the cover assembly to the display rear cover and secure them with the
following screws.
• M2.5×6C Tapping screw ×2
• M2.5×4B FLAT HEAD screw ×4
CAUTION: When tightening the M2.5
×
4B FLAT HEAD screws, apply loctite to the tip of
the screws.
2. Arrange the wireless LAN antenna cables and Bluetooth antenna cable while
passing through the hole of the cover assembly.
To Next Page
Loading...
