4 Replacement Procedures 4.20 System board
4-48 [CONFIDENTIAL] TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
Installing the System board
To install the system board, follow the steps below and refer to Figure 4-29.
1. Install the system board to the slot of the base assembly and secure it with the
following screws. Install the small arrow portion in the figure 4-29 first.
• M2.5×6C Tapping screw ×2
CAUTION: When installing the system board, make sure that the wireless
communication switch is engaged to the guide.
Tighten the screws before sticking the insulator.
2. Stick the insulator in place.
To Next Page
Loading...
