4 Replacement Procedures 4.8 Optical drive
4-24 [CONFIDENTIAL] TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
Installing the Optical drive
To install the optical drive, follow the steps below and refer to Figure 4-12 and 4-13.
1. Set the mounting plate and secure it with the following screw.
• M2×3C BIND screw ×1
2. Set the pushing plate and secure it with the following screws.
• M2×2.7C S-THIN HEAD screw ×2
3. Insert the optical drive firmly into the computer to connect it to the connector on the
system board.
4. Stick the insulator in place.
5. Turn over the computer and secure the optical drive with the following screw.
• M2.5×6B FLAT HEAD screw ×1
To Next Page
Loading...
