4 Replacement Procedures 4.5 HDD
NOTE: The following steps describe how to disassemble the HDD assembly, however, do
not disassemble if the HDD is working properly.
4. Place the HDD assembly on a flat surface, and remove the following screws.
• M3×4C FLAT HEAD screw ×4
5. Separate the HDD and HDD Holder.
CAUTION: Do not apply pressure to the top or bottom of the HDD.
M3×4C FLAT HEAD
HDD
HDD Holder
M3×4C FLAT HEAD
Figure 4-7 Separating the HDD and HDD holder
4-14 [CONFIDENTIAL] TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)
To Next Page
Loading...
