4.13 Touch pad 4 Replacement Procedures
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-37
Installing the Touch pad
To install the touch pad, follow the steps below and refer to Figure 4-21 and 4-22.
1. Connect the touch pad cable to the connector on the touch pad and stick the glass
tape.
2. Seat the touch pad assembly to the slot.
3. Install the touch pad cover while engaging latches.
4. Secure the touch pad assembly with the following screws.
• M2×5B FLAT HEAD screw ×3 (Touch pad) or ×2 (Dual pad)
CAUTION: When securing the touch pad assembly with screws, move the touch pad
cover to the front side.
To Next Page
Loading...
