4.25 LCD unit/FL inverter 4 Replacement Procedures
8. Disconnect the LCD cable from the connector CN5000 on the system board. (When
the cover assembly is removed first, the LCD cable is already disconnected.)
9. Remove the following screws and LCD unit.
• M2×3C BIND screw ×4
CAUTION: When lifting up the top of the LCD unit, hold the corners of the LCD unit.
The top edge of LCD unit is sensitive area.
LCD unit
M2×3C BIND
M2×3C BIND
LCD cable
CN5000
Hook
Figure 4-39 Removing the LCD unit
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-59
To Next Page
Loading...
