4.25 LCD unit/FL inverter 4 Replacement Procedures
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-61
Installing the LCD unit/FL inverter
To install the LCD unit/FL inverter, follow the steps below and refer to Figure 4-37 to 4-40.
1. Connect the LCD cable to the connector on the back of the LCD unit. Stick two glass
tapes in place.
2. Install the LCD unit to the display cover and secure it with the following screws.
• M2×3C BIND screw ×4
3. Arrange the LCD cable through the hook and connect the LCD cable to the
connector CN5000 on the system board.
4. Connect two cables to the FL inverter and install the FL inverter in place.
5. Insert the insulator under the LCD unit.
6. Install the LCD mask while engaging the latches.
7. Secure the LCD mask with the following screws and stick the mask seals.
• M2.5×6B FLAT HEAD screw ×2
8. Install the keyboard cover while engaging latches.
To Next Page
Loading...
