4.31 Fluorescent Lamp 4 Replacement Procedure
Assembly of Cover Ass’y, Sheets, Light guide, Tape Adhesive, Board Ass’y and Case top.
1. Assembly of Cover Ass’y and Screw (2 Points).
CAUTION: Maximum value of torque with Screw should be below 2.0kgf.cm.
2. Assembly of Light Guide and Sheets. (Reflector Sheet fixing with one Double Tape.)
CAUTION: No penetration of foreign body is indispensable with no scratch on the
surface of each Sheet and Light guide.
3. Assembly of Tape adhesive used for Sheets fixing (4 Points).
4. Assembly of Board Ass’y.
CAUTION: Pressure or stress should not be given on PCB and COF.
5. Assembly of Case top.
Figure 4-51 Replacing LG.Philips fluorescent lamp (WXGA) (5)
TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573) [CONFIDENTIAL] 4-83
To Next Page
Loading...
