E6581818
- 2 -
Handling in general
Warning
Prohibited
Do not connect or disconnect a network cable while the drive power is on.
It may lead to electric shocks or fire.
Mandatory
See the instruction manual attached with the option unit for cautions the handling.
Otherwise, it may lead to electric shocks, fire, injuries or damage to product.
Network control
Warning
Prohibited
Do not send the value out of the valid range to objects and attributes.
Otherwise, the motor may suddenly start/stop and that may result in injuries.
Mandatory
Use an additional safety device with your system to prevent a serious accident due to the
network malfunctions. Usage without an additional safety device may cause an accident.
Caution
Mandatory
Set up “Communication error trip function (see below)” to stop the drive when the option
unit is deactivated by an unusual event such as tripping, an operating error, power
outage, failure, etc.
- Network Time-Out, drive operation at disconnection, Preset speed operation
selection
(Refer to "3.3.1 Network error detection (c100 - c103)" for details)
Deactivated
the option module
may cause an accident, if the “Communication error trip
function” is not properly set up.
Make sure that the operation signals are STOP before resetting drive’s fault. The motor
may suddenly start and that may result in injuries.
Notes on operation
Notes
When the control power is shut off by the instantaneous power failure, communication
will be unavailable for a while.
The Life of EEPROM is approximately 100,000 times. Avoid writing a command more
than 100,000 times to the same parameter of the drive and the option module.
To Next Page
Loading...
Need help?
General