Toshiba TSL3000E Series - Page 57

– 56 –
INTERFACE MANUAL
STE 85457
Copyright(C) 2008 by TOSHIBA MACHINE CO.,LTD.
ALL RIGHTS RESERVED.
EXTERNAL SELECT FILE
*** [ 00 - 0F ] *****
= "PROG00"
= "PROG01"
= "PROG02"
= "PROG03"
= "PROG04"
= "PROG05"
= "PROG06"
= "PROG07"
= "PROG08"
= "PROG09"
= "PROG0A"
= "PROG0B"
= "PROG0C"
= "PROG0D"
= "PROG0E"
= "PROG0F"
The initial setting is as shown above. Specify a file name you registered
beforehand for the underlined of "PROG**".
Example:
[U08] EXTSELECT file
= "AAA"
= "BBB"
= "CCC"
= "DDD"
Specify the above program names in advance. Then specify zero (0) for both bits 1
and 2 of DIN command, which are set under [U07] (assume that [U07] = 1 2) and
input the STROBE signal. Program "AAA" is automatically selected now. (If the
following steps are taken without registering the program names, a "Compile Error"
occurs.)
After the above parameter has been changed, save the data, turn the power off and
on again. Otherwise, the parameter will not be operative.