Installing Your Walk-and-Talk Whiteboard 15
PolyVision
®
The table below explains the Projection Mode Active LED indications.
Sounds
While you use your whiteboard, sounds indicate the status of the system.
You can disable or enable sounds; refer to the on-line
Polyvision User
Guide
for information about sounds and other driver options.
The following sounds indicate the whiteboard status:
Projection Mode
Active LED
Meaning
Off The Walk-and-Talk whiteboard is capturing dry-
erase ink over the entire surface of the board and is
not controlling the computer.
Yellow The Walk-and-Talk whiteboard is controlling the
computer where the image is projected and
capturing dry-erase ink elsewhere.
Blinking yellow Projection alignment is needed. Press the Projection
button on the remote control to re-align the image.
Sound Condition
Fanfare Software launch or power on
Flop Software exit or critical hardware errors
Click Alignment point tapped or remote button pressed
PolyVision I&O.book Page 15 Thursday, October 16, 2008 4:18 PM
To Next Page
Loading...