Touchboards PolyVision - Using Your Polyvision Interactive Whiteboard; Using Dry-Erase Markers with Your Board

Using Your PolyVision Interactive Whiteboard 23
PolyVision
®
Using Your PolyVision Interactive Whiteboard
Using Dry-Erase Markers with Your Board
Your PolyVision whiteboard senses writing and erasing that you can print or
save by detecting pressure.
• Use only the eraser provided with your whiteboard.
• Use firm consistent pressure.
• Make sure there is only one point of contact at a time.
note:NOTE:
The whiteboard surface can be damaged by sharp objects such as
ballpoint pens and rulers.
To write on the board so it can be saved or printed:
1 Choose a dry-erase marker.
2 Press an ink color button on the remote control (Walk-and-Talk
models) or tap a pen color icon on the whiteboard (TS models)
corresponding to the marker color.
3 Write on the board.
When you write on the board:
• Walk-and-Talk models: the red “Ink Recorded” LED glows to indicate
that the computer has detected your writing. Refer to “LED and Status
Messages on the Walk-and-Talk Whiteboard” on page 12.
• TS models: the whiteboard provides audible feedback and the green
LED glows brighter to indicate that it recognizes your strokes.
You can print or save your notes as a digital image on your computer. To
save your writing:
• Press the Print or Save button on the remote control (Walk-and-Talk
models) or tap the Print or Save icon on the whiteboard (TS models).
A snapshot of the writing is saved on your computer.
To erase so it is recorded:
• Walk-and-Talk models: erase using the large circular felt eraser
provided. The battery-operated eraser sends infrared data to the
computer through the whiteboard.
PolyVision I&O.book Page 23 Thursday, October 16, 2008 4:18 PM