Software
TOX_Manual_Process-monitoring-unit_CEP400T_en
77
By tapping the text fields Measuring value 1 or Measuring value 2 the
values of the measured electrical signals can also be changed before
tapping the Accept calibration button.
This should, however, only be made when the allocation of the electrical
signal for force is known.
Apply configuration
If a value or a setting has been changed in menu ''Configuration -> Configu-
ration of force sensor'', a request dialog is displayed when exiting the
menu.
In this window the following options can be selected:
Only for this process:
The changes only apply to the current process and overwrite the previ-
ous values/settings in the current process.
Copy to all processes
The changes apply to all processes and overwrite the previous values/
settings in all processes.
Copy to the following processes
The changes are only accepted in the area that has been specified in
fields From process to process. The previous values/settings are
overwritten in the defined process area with the new values.
Cancel entry:
The changes are discarded and the window is closed.
To Next Page
Loading...