TOX PRESSOTECHNIK CEP400T - Page 91

Software
TOX_Manual_Process-monitoring-unit_CEP400T_en
91
Selection by Function Buttons
ü The user is logged in with a suitable user level. The necessary write
permissions are available.
1. Select the Profibus address by tapping the ⇒ or ⇐ buttons.
2. Restart the device.
Enable the remote access
The remote access for TOX
®
PRESSOTECHNIK can be enabled in menu
''Supplement \ Configuration parameters\Remote access''.
ü The user is logged in with a suitable user level. The necessary write
permissions are available.
ü Menu ''Supplement -> Configuration parameters\Remote access'' is
open.
è Tap on the Remote access button.
w Remote access is enabled.
In-/Outputs
In the ''Supplement -> In-/Outputs'' menu the user can:
 Check the current status of the internal digital inputs and outputs.
 Check the current status of the field bus inputs and outputs.
Checking the internal In-/Outputs
In menu ''Supplement -> In-/Outputs I Internal I/O'' the current status of the
internal digital inputs and outputs can be checked.
Status:
 Active: The corresponding input or output is marked with a green
square.
 Not active: The corresponding input or output is marked with a red
square.