Toyota 2GR-FE - Remove Camshaft Housing Sub-Assembly RH

EM–78
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
EM
40. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY RH
(a) Remove the camshaft housing sub-assembly RH by
prying between the cylinder head and camshaft
housing sub-assembly RH with a screwdriver.
NOTICE:
Be careful not to damage the contact surfaces of
the cylinder head and camshaft housing.
HINT:
Tape the screwdriver tip before use.
41. REMOVE CAMSHAFT TIMING GEARS AND NO. 2
CHAIN (for Bank 2)
(a) While pushing down the No. 3 chain tensioner,
insert a pin of φ 1.0 mm (0.039 in.) into the hole to fix
the No. 3 chain tensioner.
(b) Hold the hexagonal portion of the camshaft with a
wrench, and remove the 2 bolts and 2 camshaft
timing gear assemblies.
NOTICE:
• Be careful not to damage the cylinder head
with the wrench.
• Do not disassemble the camshaft timing gear
assemblies.
(c) Remove the No. 2 chain.
Protective Tape
Protective Tape
A129703E01
Pin
Push
Plunger
A120657E01
Turn
Hold
A120658E01