Toyota 2GR-FE - Remove Exhaust Manifold Sub-Assembly RH

EM–32
2GR-FE ENGINE MECHANICAL – ENGINE ASSEMBLY
EM
(e) Remove the bolt and vacuum hose clamp.
(f) Disconnect the connector.
(g) Remove the 4 bolts, No. 1 surge tank stay and
throttle body bracket.
(h) Using a 5 mm socket hexagon wrench, remove the
4 bolts.
(i) Remove the 2 nuts and intake air surge tank.
(j) Remove the gasket from the intake air surge tank.
70. REMOVE IGNITION COIL ASSEMBLY
(a) Remove the 6 bolts and 6 ignition coils.
71. REMOVE NO. 2 ENGINE MOUNTING STAY RH
(a) Remove the bolt and No. 2 engine mounting stay
RH.
72. REMOVE INTAKE MANIFOLD
(a) Uniformly loosen and remove the 6 bolts and 4 nuts.
(b) Remove the intake manifold and 2 gaskets.
73. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
(a) Disconnect the A/F sensor connector clamp.
(b) Uniformly loosen and remove the 6 nuts.
(c) Remove the manifold and gasket.
A129466
A129467
(i)
(i)
(h)
(h)
(h)
(h)
A139209E01
A134933
A129637