ST–32
2GR-FE STARTING – SMART KEY SYSTEM
ST
ON-VEHICLE INSPECTION
1. CHECK POWER SOURCE MODE CHANGE
FUNCTION
(a) Check the function of the engine switch.
(1) Check that power source mode changes in
accordance with the conditions of the shift
position and brake pedal.
(b) Check if power source mode changes without
pressing the engine switch.
(1) With power source mode on (ACC) and the
shift position in P, wait for at least 1 hour. Check
that power source mode changes from on
(ACC) to off automatically.
2. CHECK INDICATOR CONDITION
(a) Check the indicator on the engine switch.
(1) Check that the engine switch indicator turns on
and changes color according to the table
below.
Brake Pedal Shift Lever Power Source Mode Pattern
Depressed P or N Position
When the engine switch is pushed once.
•off → engine start
• on (ACC) → engine start
• on (IG) → engine start
Not depressed
P position
Each time the engine switch is pushed.
•off → on (ACC) → on (IG) → off
Except P Position
Each time the engine switch is pushed.
•off → on (ACC) → on (IG) → on (ACC)
- P Position
When the engine switch is pushed with power source mode on (IG) (engine running).
• on (IG) → off
- Except P Position
When the engine switch is pushed with power source mode on (IG) (engine running).
• on (IG) → on (ACC)
START
STOP
Indicator Light
A109251E01
Power Source Mode/Condition
Indicator Light Condition
Brake pedal released Brake pedal depressed, shift lever in P or N
off OFF ON (Green) (When key and vehicle IDs match)
on (ACC, IG) ON (Amber) ON (Green)
Engine running OFF OFF
Steering lock not unlocked Flashes (Green) for 15 sec. Flashes (Green) for 15 sec.
System malfunction Flashes (Amber) for 15 sec. Flashes (Amber) for 15 sec.
To Next Page
