320
3-2. Using the audio system
■ Release Tones
“Release Tones” appear when a continuous tone signal(s) containing
a (w) is registered in the contact list.
Select “Release Tones”.
■ Release Tones
● A continuous tone signal is a character string that consists of numbers
and the characters p or w. (e.g.056133w0123p#1∗)
● When the “p” pause tone is used, the tone data up until the next pause
tone will be automatically sent after 2 seconds have elapsed. When the
“w” pause tone is used, the tone data up until the next pause tone will be
automatically sent after a user operation is performed.
● Release tones can be used when automated operation of a phone based
service such as an answering machine or bank phone service is desired.
A phone number with continuous tone signals can be registered in the
contact list.
● Tone data after a “w” pause tone can be operated on voice command
during a call.
To Next Page
Loading...
Need help?
General
