168
4-3. Operating the lights and wipers
RUSH_OM_General_OMBZ265
With the headlights on, push
the lever away from you to turn
on the high beams.
Pull the lever toward you to the
center position to turn the high
beams off.
Pull the lever toward you and
release it to flash the high
beams once.
You can flash the high beams with the headlights on or off.
■ Headlight control sensor (if equipped)
■ Automatic light off system
Opening the driver’s door with the engine switch in ACCESSORY or off will
turn the headlights and tail lights off.
To turn the lights on again, turn the engine switch to IGNITION ON mode, or
turn the headlight switch off once and then back to or .
■ Light reminder buzzer
A buzzer sounds when the engine switch is turned off and the driver’s door is
opened while the lights are turned on.
Turning on the high beam headlights
KBTE430102E
1
2
The sensor may not function properly if an
object is placed on the sensor, or anything
that blocks the sensor is affixed to the
windshield.
Doing so interferes with the sensor
detecting the level of ambient light and
may cause the automatic headlight sys-
tem to malfunction.
Air conditioning operation may also be
interrupted.
To Next Page
Loading...
