Toyota Rush - After Completing the Tire Change; Stowing the Jack and Tools

330
7-2. Steps to take in an emergency
RUSH_OM_General_OMBZ265
When the tire is hoisted up,
make sure that the tire is
securely fixed.
Rock the tire up and down.
Turn the tire around.
Confirm directly with your eyes that
the tire is not interfering with any
surrounding parts.
If the tire is loose or not properly
stored, loosen the clamp bolt and
repeat from the step .
Stow the tools.
Put the arm onto portion of
the bracket, as shown in the
illustration.
Be sure to adjust the arm so that
portions of the bracket are
inside the arm.
Turn the joint until the arm is
brought into contact with the
bracket.
■ After completing the tire change (vehicles with a tire pressure warning
system)
The tire pressure warning system must be reset. (→P. 262)
KBTE820423
4
1
2
3
Stowing the jack and tools
1
KBTE820424
Bracket
Arm
2
KBTE820425
3