69
1-2. Child safety
1
For safety and security
RUSH_OM_General_OMBZ265
■
i-Size child restraint systems fastened with ISOFIX (ECER129)-
Compatibility table
If your child restraint system is of “i-Size” category, you can install it
on the positions mentioned by i-U in the table below.
Child restraint system category can be found in the child restraint
system manual.
I-U= Suitable position for “universal” i-Size CRS.
X= Not suitable position for “universal” i-Size CRS.
*
1
Place the second seat at the 4th lock position from the rear most
position. Adjust the seat back to 3rd lock position from the most
upright position. If the adjustment above cannot assure the
proper seating position, install the child restraint on the second
seat behind the front passenger seat.
*
2
If the child seat cannot be installed due to interference between
the head restraint and the child seat, set the head restraint to the
upper most position or remove it.
When securing some types of child restraint systems in second
seat, it may not be possible to properly use the seat belts in posi-
tions next to the child restraint without interfering with it or affecting
seat belt effectiveness. Be sure your seat belt fits snugly across
your shoulder and low on your hips. If it does not, or if it interferes
with the child restraint, move to a different position. Failure to do so
may result in death or serious injury.
The child restraint systems mentioned in the table may not be avail-
able outside the ASEAN area.
● When installing a child restraint in the second seats, adjust the
front seat so that it does not interfere with the child or child
restraint system.
Seating position
Recommended
CRS
Front Second seat
Third seat
(If
equipped)
Passenger
seat
Outboard Center
i-Size CRS X I-U
*
1, 2
XXi-Size MIDI
To Next Page
Loading...
