TP-Link JetStream T2700G-28TQ - Page 156

144
Admin Status: Specify interface administrator status. Choose 'Disable
' to
disable the interface's Layer 3 capabilities.
Interface Name: Specify the name of the network interface.

Interface List
Select : Select the interfaces to modify or delete.
ID: Displays the ID of the interface.
Mode: Display IP address allocation mode.
None: without ip.
Static: setup manually.
DHCP: allocated through DHCP.
BOOTP: allocated through BOOTP.
IP Address: Displays the IP address of the interface.
Subnet Mask: Displays the subnet mask of the interface.
Interface Name: Displays the name of the interface.
Status:
Displays interface current working status. Working status is up
when admin status i
s enable, line protocol is up and IP Address is
set.
Operation: You can configure the interface by clicking the "Edit
", or check
Detail information by clicking "Detail".
Click Edit to display the following figure:
Figure 10-2 Interface Modify

Modify Interface
Interface ID: Displays ID of the interface, including VLAN ID
, loopback
interface and routed port.
Mode: View and modify the IP address allocation mode.
None: without ip.
Static: setup manually.
DHCP: allocated through DHCP.
BOOTP: allocated through BOOTP.
IP Address: View and modify the IP address of the interface.
Subnet Mask: View and modify the subnet mask of the interface.