TP-Link TL-SL2210 - Page 15

5
The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Mode Accessing Path Prompt
Logout or Access the
next mode
User EXEC
Mode
Primary mode once it is
connected with the switch.
TL-SL2428>
Use the exit command to
disconnect the switch.
Use the enable command to
access Privileged EXEC
mode.
Privileged
EXEC Mode
Use the enable command to
enter this mode from User
EXEC mode.
TL-SL2428#
Enter the disable or the exit
command to return to User
EXEC mode.
Enter the configure
command to access Global
Configuration mode.
Global
Configuration
Mode
Use the configure command
to enter this mode from
Privileged EXEC mode.
TL-SL2428 (config)#
Use the exit or the end
command or press Ctrl+Z to
return to Privileged EXEC
mode.
Use the interface
fastEthernet/
gigabitEthernet port or
interface range
fastEthernet/gigabitEthernet
port-list command to access
interface Configuration mode.
Use the vlan vlan-list to
access VLAN Configuration
mode.
Global Configuration
Mode
Privileged EXEC
Mode
User EXEC Mode
Interface Configuration Mode
Interface fastEthernet
Interface gigabitEthernet
Interface link-aggregation
Interface range fastEthernet
Interface range gigabitEthernet
Interface range link-aggregation
Interface vlan
……
password
VLAN Confi
g
uration Mode