TP-Link TL-SL2210 - 8.1 IGMP Snooping

73
User Guidelines
Command in the Interface Range fastEthernet Mode is executed
independently on all ports in the range. It does not effect the execution on the
other ports at all if the command results in an error on one port.
Example
To enter the Interface Range fastEthernet Configuration Mode, and configure
ports 1, 2, 3, 6, 7 and 9 at the same time by adding them to one port-list:
TL-SL2428(config)#interface range fastEthernet 1/0/1-3,1/0/6-7,1/0/9
interface gigabitEthernet
Description
The interface gigabitEthernet command is used to enter the interface
gigabitEthernet Configuration Mode and configure the corresponding Gigabit
Ethernet port.
Syntax
interface gigabitEthernet port
Parameter
port —— The Fast/Gigabit Ethernet port number.
Command Mode
Global Configuration Mode
Example
To enter the Interface gigabitEthernet Configuration Mode and configure Gigabit
Ethernet port 27:
TL-SL2428(config)#interface gigabitEthernet 1/0/27
interface range gigabitEthernet
Description
The interface range gigabitEthernet command is used to enter the interface
range gigabitEthernet Configuration Mode and configure multiple Gigabit
Ethernet ports at the same time.
Syntax
interface range gigabitEthernet port-list