TP-Link TL-SL2210 - Flow-Control

75
Description
The shutdown command is used to disable an Ethernet port. To enable this port
again, please use no shutdown command.
Syntax
shutdown
no shutdown
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Disable port 3:
TL-SL2428(config)# interface fastEthernet 1/0/3
TL-SL2428(config-if)# shutdown
flow-control
Description
The flow-control command is used to enable the flow-control function for a port.
To disable the flow-control function for this corresponding port, please use no
flow-control command. With the flow-control function enabled, the Ingress
Rate and Egress Rate can be synchronized to avoid packet loss in the network.
Syntax
flow-control
no flow-control
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the flow-control function for port 3:
TL-SL2428(config)# interface fastEthernet 1/0/3
TL-SL2428(config-if)# flow-control