32
Chapter 4
Congure the Access Point
Now only client A and client B can access your network.
4. 3. 7. Wireless Advanced
The configuration of each operation mode is almost the same. We take Access Point
mode for example here.
1. Visit http://tplinkap.net, and log in with the username and password you set for the
access point.
2. Go to Wireless > Wireless Advanced.
3. Configure the advanced settings of your wireless network and click Save.
Note:
If you are not familiar with the setting items on this page, it’s strongly recommended to keep the provided default values;
otherwise it may result in lower wireless network performance.
• Transmit Power - Select High, Middle or Low which you would like to specify for the
access point. High is the default setting and recommended.
• Beacon Interval - Enter a value between 40-1000 milliseconds for Beacon Interval
here. Beacon Interval value determines the time interval of the beacons. The beacons
are the packets sent by the access point to synchronize a wireless network. The
default value is 100.
• RTS Threshold - Here you can specify the RTS (Request to Send) Threshold. If the
packet is larger than the specified RTS Threshold size, the access point will send RTS
Done!
To Next Page
Loading...
