34
Chapter 4
Congure the Access Point
4. 3. 9. Throughput Monitor
1. Visit http://tplinkap.net, and log in with the username and password you set for the
access point.
2. Go to Wireless > Throughput Monitor to view the wireless throughput information.
• Rate - The Throughput unit.
• Run Time - How long this function is running.
• Transmit - Wireless transmit rate information.
• Receive - Wireless receive rate information.
Click Start/Stop to start or stop wireless throughput monitor.
4. 4. DHCP
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and
the access point acts as a DHCP server; it dynamically assigns TCP/IP parameters to
client devices from the IP Address Pool. You can change the settings of DHCP Server if
necessary, and you can reserve LAN IP addresses for specified client devices.
4. 4. 1. DHCP Settings
1. Visit http://tplinkap.net, and log in with the username and password you set for the
access point.
2. Go to Network > DHCP Settings.
3. Specify DHCP server settings and click Save.
To Next Page
Loading...
