80
Chapter 7
Customize Your Network Settings
6. When the WPS LED is on, the client device has successfully connected to the router.
Note:
1. The WPS LED on the router will light on for five minutes if the device has been successfully added to the network.
2. The WPS function cannot be configured if the wireless function of the router is disabled. Please make sure the
wireless function is enabled before configuring WPS.
Method 4: Enter the client device’s PIN on the router
1. Visit http://tplinkmodem.net or http://192.168.1.1, and log in with the password you
set for the GPON router.
2. Go to Advanced > Wireless > WPS, and click PIN Number.
3. Enter the Client’s PIN.
4. Then click the Connect button.
5. Device has been added successfully! or the similar information will appear on the
web page, which means the client device has successfully connected to the router.
To Next Page
Loading...
