9.5 Erasing Records from the Logger
To erase records from the Logger…
1. Select the Erase Logger menu ( →→ F3:Logger →→ F2:Erase)
2. The 90-FL now displays the Erase menu, for example…
Erase Logger, ( 100 ) Select Option
F1:Erase All F2:Erase Last Menu Exits
The number of readings stored in the Logger is displayed. See the “100” in the example above.
3. Press to erase all of the readings stored in the Logger.
Press to erase the last recorded reading only.
Press to quit without erasing any records.
9.6 Printing Records from the Logger to the RS232 Port
1. Connect one end of the RS232 cable to the Charger socket of the 90-FL.
2. Connect the other end of the RS232 cable to an RS232 Printer, or to the COM1 or COM2 ports
of a PC.
3. Ensure that the baud rate for the printer or PC and the 90-FL are the same. If necessary, alter
the baud rate of the 90-FL (see section 10.1).
The 90-FL uses XON/XOFF protocol. Ensure that the printer is set accordingly.
4. Select the Logger menu. ( →→ F3:Logger).
5. Select F3:Print Log from the menu.
6. Printing starts as soon as is pressed. The display shows the word “Printing” until
printing is completed.
To Next Page
Loading...
