• Look – a single button press to view graphics during programming
• Math Help – for finding points in a prompted format with graphical
representation of prompts
• Machine Tool Error Compensation and Backlash Compensation custom set
on mill after installation
• Selectable Inch/mm measurement readout
• Jog of X and Y from 1 to 100 inches per minute
• Selectable 2 or 3-axis operation
• AGE Auto Geometry Engine
Programmed Canned Cycles
• Posn/Drill – single point
• Bolt Hole – series of points evenly spaced around a circle
• Mill – straight line in any direction
• Arc – any portion of a circle
• Pocket – a rectangle, circle or irregular and all the material inside, includes
finish cut
• Profile – a perimeter of a rectangle, circle or irregular shape, includes
finish cut
• Repeat, Rotation, Mirror – of programmed events with or without offset
Options
• Remote Stop/Go (RSG) switch
• USB thumb drive for program storage and transfer. (See pg. 12, under
The USB Ports)
• Offline programming system
• DXF and Parasolid programming on Offline
To Next Page