TRAK KMX Knee Mill, Bed Mill & ProtoTRAK KMX CNC Retrofit Safety, Programming, Operating & Care Manual
Test port
Used by the factory for testing only.
Grd (Ground)
We recommend that you ground the ProtoTRAK display to an earth ground such
as a cold water pipe.
A/C Inlet
To plug in the incoming 110v power. The on/off switch is located directly below
this inlet.
CBB Pwr
110 volts out to power the cable breakout box if included. Provides power for
110 volt outlet for AUX functions
AC Spdl EN
Logic cable to enable and/or turn off the spindle to certain SWI machines only
RSG
Remote Stop and Go switch
Mach ID
Machine ID key to customize parameters to each machine type
UMB1 and UMB2
Logic connections to the Cable Breakout Box
Network
Network connection to your server, computer or other ProtoTRAKs
Upgrade Aux
Interface to DPM Bed Mill upgrade auxiliary hardware
SPDL and Upgrade SW-Box
Interfaces to upgraded DPM bed mills with separate Switch Boxes
3.2.3 Servo Motors/Amplifiers
The ProtoTRAK KMX servomotor and amplifier have been combined into a single
integrated package on each axis. The motors are rated 280 in-oz. maximum
continuous torque that is sufficient for the heaviest cuts.
3.2.4 Ballscrews
Precision ballscrews are installed in the table and saddle to ensure smooth
traverse and positive control for manual and CNC machining.
To Next Page
Loading...