TRAK K3KMX - Page 6

iv
Southwestern Industries, Inc.
TRAK KMX Knee Mill, Bed Mill & ProtoTRAK KMX CNC Retrofit Safety, Programming, Operating & Care Manual
10.1 TOOL TABLE 61
10.2 TOOL PATH 62
10.3 Setting Home 64
10.4 STEP UP & STEP DOWN – 3-Axis Mills in 2-Axis Mode 64
10.5 Verify 65
10.6 Service Codes 65
11.0 Program Run Mode 66
11.1 Setting Up 66
11.2 Starting 66
11.3 Display Messages in Program Run 66
11.4 Program Run Prompts 68
11.5 Stop 68
11.6 Feedrate Override 68
11.7 TRAKing / Electronic Handwheel Option 68
11.7.1 TRAKing in Two-Axis CNC 69
11.8 Data Errors 69
11.9 Fault Messages 69
12.0 Program Memory & Storage 70
12.1 Cautions About Opening and Deleting Programs 70
12.2 Program Formats and Labeling 71
12.3 Opening a Program from the ProtoTRAK KMX Thumb Drive 71
12.3.1 Open Temp 72
12.4 Saving a Program Onto the ProtoTRAK KMX Thumb Drive 72
12.4.1 Save Temp Procedure 73
12.5 Deleting a Program on Your ProtoTRAK KMX Thumb Drive 73
12.6 Erase Current Program 73
12.7 Thumb Drive 74
12.8 Opening and Running G-Code and CAM Files 74
12.9 Networking 75
13.0 Math Help 82
13.1 Procedure 82
13.2 Math Help Types 84
14.0 Service Codes 85
TRAK Warranty Policy 88