TRAK KMX Knee Mill, Bed Mill & ProtoTRAK KMX CNC Retrofit Safety, Programming, Operating & Care Manual
When this is the case, you should double check the following:
1) The Location / path specified is correct. Check spelling, case sensitivity,
spaces, etc.
2) All your physical connections and devices. This includes Ethernet cables,
routers, switches, etc.
3) Make sure that location specified is properly being shared, and is accessible
by this device.
Network Setup
Our ProtoTRAK KMX control only has the ability to open a network path that is openly
being shared, without any username / password restrictions. If this is the case, simply
connecting your ProtoTRAK KMX directly to your PC or to a hub or router that the PC is
connected to, should be all that is needed in order for this to work.
To Next Page
Loading...