TK 55711-19-OP-EN
11
Take IMMEDIATE action after a person has received an electrical shock. Get
quick medical assistance, if possible.
The source of the shock must be quickly stopped, by either shutting off the
power or removing the victim. If the power cannot be shut off, the wire
should be cut with an non-conductive tool, such as a wood-handle axe or
thickly insulated cable cutters. Rescuers should wear insulated gloves and
safety glasses, and avoid looking at wires being cut. The ensuing flash can
cause burns and blindness.
If the victim must be removed from a live circuit, pull the victim away with a
non-conductive material. Use wood, rope, a belt or coat to pull or push the
victim away from the current. DO NOT TOUCH the victim. You will receive a
shock from current flowing through the victim’s body. After separating the
victim from power source, immediately check for signs of a pulse and
respiration. If no pulse is present, start Cardio Pulmonary Resuscitation
(CPR). If a pulse is present, respiration might be restored by using mouth-to-
mouth resuscitation. Call for emergency medical assistance.
AASSPPHHYYXXIIAATTIIOONN
Move victim to fresh air and use Cardio Pulmonary Resuscitation (CPR) or
mouth-to-mouth resuscitation to restore breathing, if necessary. Stay with
victim until emergency personnel arrive.
Electrical Hazards
Low Voltage
WWAARRNNIINNGG
LLiivvee EElleeccttrriiccaall CCoommppoonneennttss!!
Control circuits used in the auxiliary power unit are low voltage (12 to 28
volts dc). This voltage potential is not considered dangerous, but the large
amount of amperage available can cause severe burns if shorted or
grounded. Do not wear jewelry, watches, or rings because they increase the
risk of shorting out electrical circuits and damaging equipment or causing
severe burns.
CCAAUUTTIIOONN
RRiisskk ooff IInnjjuurryy!!
Always disconnect power at the battery before removing or repairing
electrical components. Failure to do so may result in personal injury or
damage to the equipment.
SSaaffeettyy
To Next Page
Loading...