Trane Technologies Thermo King TriPac Evolution - Engine Oil Change Intervals

42
TK 55711-19-OP-EN
Pretrip 500 Hrs Annual 2,000 Hrs
Check condition of or service the following:
—
Test fuel injection nozzles at least every 3,000 hours.*
—
Replace fuel return lines between fuel injection nozzles every 10,000
hours or sooner, as required.
* Based on EPA 40 CFR Part 89.
Engine Oil Change Intervals
((CChhaannggee ooiill aanndd ffiilltteerrss hhoott))
Pretrip 500 Hrs Annual 2,000 Hrs
Check condition of or service the following:
• 2,000 Hour Interval– Oil change interval is every 2,000 hours of
operation only when using a Thermo King brand oil filter and CK-4 or
better oil. Units with optional DPF require CK-4 or better oil. FA-4 is not
approved.
•
500 Hour Interval – Oil change interval is every 500 hours of
operation when using any other brand oil filter and CI-4 or better oil.
Units with optional DPF require CK-4 or better oil.
Important: The fill port on top of the engine should not be used to add engine oil. To
prevent engine lock-up and/or serious internal damage after TriPac engine oil
is added or changed always add oil through the lower port on the timing gear
cover.
MMaaiinntteennaannccee IInnssppeeccttiioonn SScchheedduullee