8
TK 55711-19-OP-EN
Safety Precautions
Thermo King recommends all services be performed by a Thermo King
dealer. However, there are several general safety practices you should be
aware of:
DDAANNGGEERR
FFiirree HHaazzaarrdd!!
Always turn the TriPac system OFF at the HMI Control Panel On/Off button
while the truck is being refueled. Fuel vapors could ignite if they come in
contact with TriPac electrical or heater components.
DDAANNGGEERR
RRiisskk ooff IInnjjuurryy!!
Keep your hands, clothing, and tools clear of moving parts when the unit is
operating or vehicle’s engine is running. Loose clothing can become
entangled in moving parts, causing serious injury or possible death.
WWAARRNNIINNGG
PPeerrssoonnaall PPrrootteeccttiivvee EEqquuiippmmeenntt ((PPPPEE)) RReeqquuiirreedd!!
Always wear goggles or safety glasses when working with or around the
refrigeration system or battery. Refrigerant or battery acid can cause
permanent damage if it comes in contact with your eyes.
WWAARRNNIINNGG
EEqquuiippmmeenntt DDaammaaggee aanndd RRiisskk ooff IInnjjuurryy!!
Never drill holes into the unit unless instructed by Thermo King. Holes
drilled into high voltage cables could cause an electrical fire, severe
personal injury, or even death.
WWAARRNNIINNGG
RRiisskk ooff IInnjjuurryy!!
Turn the unit HMI Controller Off before opening the Battery Box or
inspecting any part of the unit.
CCAAUUTTIIOONN
SShhaarrpp EEddggeess!!
Exposed coil fins can cause lacerations. Service work on the evaporator or
condenser coils is best left to a certified Thermo King technician.
SSaaffeettyy
To Next Page
Loading...