Trane TR200 - Page 35

Parameter Selection
In main menu mode, the parameters are divided into
groups. You select a parameter group by means of
the navigation keys.
The following parameter groups are accessible:
Group no. Parameter group:
0 Operation/Display
1 Load/Motor
2 Brakes
3 References/Ramps
4 Limits/Warnings
5 Digital In/Out
6 Analog In/Out
8 Comm. and Options
11 LonWorks
13 Smart Logic
14 Special Functions
15 Drive Information
16 Data Readouts
18 Data Readouts 2
20 Drive Closed-loop
21 Ext. Closed-loop
22 Application Functions
23 Time-based Functions
24 Application Functions 2
After selecting a parameter group, choose a param-
eter by means of the navigation keys.
The middle section on the display shows the param-
eter number and name as well as the selected pa-
rameter value.
Changing Data
The procedure for changing data is the same whether you select a parameter in the quick menu or the main
menu mode. Press [OK] to change the selected parameter.
The procedure for changing data depends on whether the selected parameter represents a numerical data value
or a text value.
How to Program
3-16 TR200 Programming Guide