© Copyright 2012 TRENDnet. All Rights Reserved.
28
TRENDnet User’s Guide
TEW-715APO
AP Repeater Mode
Wireless > Basic
When Router mode is applied as the system mode and the operation mode is set to AP
Repeater, the access point serves as a wireless router. This section outlines available
management options under the Basic Settings of the Wireless button when the
Operation Mode is set to Bridge and will assist in setting up the access point. Click Apply
to save any changes.
• Disable Wireless LAN Interface:
o Check/Off: turns off wireless networking on your router.
o Unchecked/On: turns on the wireless networking on your router (by default
it is enabled).
Note: It is recommended to leave the wireless setting to On unless you do not plan
on connecting any wireless computers or devices to your network.
• Operation Mode: Select the mode you want the access point to operate in.
o AP: refer to pagexxxx for additional information.
o Wireless Client: refer to page xxx for additional information
o Bridge: refer to page xxx for additional information
o AP Repeater: refer to page xxx for additional information to operate the
device as an access point.
• Wireless Network Name (SSID): This acronym stands for Service Set Identifier
and is the name of your wireless network. You can manually enter the wireless
network you want to repeat.
• Broadcast SSID:
o Enable: Access point will broadcast the your wireless network name (SSID),
making it easier for wireless clients to find the wireless network.
To Next Page
Loading...
