© Copyright 2012 TRENDnet. All Rights Reserved.
7
TRENDnet User’s Guide
TEW-715APO
Getting Started
For a typical wireless setup at home or office when using the access point in AP mode,
please do the following:
Hardware Installation
1. Remove the bottom cap.
2. Plug a Network cable to the Ethernet port.
3. Slide the bottom cover back to the unit.
4. Plug an Ethernet cable to the access point and plug the other end of the cable to the
side of the PoE adapter marked PoE.
5. Take another Ethernet cable and plug it on the side of the PoE adapter marked LAN,
plug the other end of the cable to your network.
6. Verify that the following LED indicators on the access point: Power (Solid Green), LAN
(Solid/Blinking Green) and WLAN (Blinking Green).
7. Open your web browser (e.g. Internet Explorer, Firefox, Safari, Chrome, or Opera) and
go to http://192.168.10.1
00. The access point will prompt you for a password.
8. Enter the default user name and password and then click Login.
Default System Password: admin
To Next Page
Loading...
Need help?
General
