TRENDnet TEW-715APO - Page 43

© Copyright 2012 TRENDnet. All Rights Reserved.
42
TRENDnet User’s Guide
TEW-715APO
3. Select the management mode you would like to use. Click Apply to save settings.
• Normal: Select this mode to activate Telnet, SNMP and FTP
• Secure: Select this mode to activate SSH, HTTPS, and WISE
• Customized: Select this mode to manually choose the management modes
4. If SNMP is one of the management tools you have selected. You will need to complete
the below settings.
• Protocol Version: Select from the pull down menu the SNMP version to use.
• Server Port: Enter the your SNMP server port
• Get Community: Enter the password for the incoming Get and GetNext requests
from the management station
• Set Community: Specify the password for the incoming Set requests from the
management station.
• Trap Destination: Specify the IP address of the station to send the SNMP traps to.
• Trap Community: Specify the password sent with each trap to the manager.
To use SNMP V3, click the option “Configure SNMPv3 User Profile” to display the
configuration settings.
• User Name: Specify a user name for the SNMPv3 administrator or user. Only the
SNMP commands carrying this user name are allowed to access the access point
• Password: Specify a password for the SNMPv3 administrator or user. Only the
SNMP commands carrying this password are allowed to access the access point
• Confirm Password: Input password again to confirm
• Access Type: Select “Read Only” or “Read and Write” accordingly.
• Authentication Protocol: Select an authentication algorithm. SHA authentication
is stronger than MD5 but is slower.
• Privacy Protocol: Specify the encryption method for SNMP communication. None
and DES are available.
o None: No encryption is applied.
o DES: Data Encryption Standard, it applies a 58-bit key to each 64-bit
block of data.