© Copyright 2015 TRENDnet. All Rights Reserved.
FAT AP
Below describes the configuration settings when the TEW-730APO System Mode is set
to FAT AP mode. The features and configuration settings in FAT AP is similar to most
wireless access points in the market. It creates a wireless network in your environment,
the device also be configured as a bridge, repeater or wireless client in FAT AP mode.
Configuration
1. Log into the management page (see “Access the management page” on page 9).
2. Your access point will prompt you for a user name and password.
3. Enter the default user name and password and then click Login.
Default User Name: admin
Default Password: admin
4. Click the System button on the left side and then System Settings.
5. Select Fat AP in the Device Mode drop down menu and Select your Country/Region.
6. Click Apply button to save your setting.
7. Click the Wireless button on the left side and then Basic Settings.
8. Select the mode you would like to apply Operation Mode pull down menu.
AP: Creates a wireless network to your existing network. Device Ethernet port
serves as a LAN (Local Area Network) port of the device
Wireless Client: Connects to any existing wireless network (similar to a wireless
adapter). Device Ethernet port serves as a LAN (Local Area Network) port of the
device
Bridge: Creates a wireless bridge connection with another access point. Ethernet
port serves as a LAN (Local Area Network) port of the device
AP Repeater: Repeats the wireless signal of an existing wireless network. Device
Ethernet port serves as a LAN (Local Area Network) port of the device
To Next Page
Loading...
Need help?
General
