© Copyright 2015 TRENDnet. All Rights Reserved.
DHCP Client: Select to enable DHCP server
o DHCP IP Address Range: Enter the DHCP IP range to assign
o Subnet Mask: Enter the Subnet mask to assign DHCP clients
o Lease Time: Enter the lease time duration for DHCP clients.
ZNMP
ZNMP Survey Interval: Enter the survey time interval
o P Address: Enter the IP address to assign
o Subnet Mask: Enter the subnet mask of the access point
o Gateway IP Address: Enter the gateway IP address
AP Management
This page displays thin access points connected in the network.
1. Log into the management page (see “Access the management page” on page 9).
2. Click on Status section and Managed APs.
3. Select the access point you would like to configure.
Restart: Click this option to restart the selected device(s)
Rename: Click this option to rename the selected access point
Set IP: Click this option to change the IP address of the selected device
Radio: Select this option to change the wireless radio settings of the selected
device
Upgrade Selected: Select this option to upgrade the selected devices
Upgrade All: Select this option to upgrade all devices
Refresh: Click to refresh the access point list
Advance Settings
Setting time
1. Log into the management page (see “Access the management page” on page 9).
2. Click on System, and click on Time Settings.
Manual configure time settings
1. Manually enter the date and time settings.
2. Next to Time Zone Select, select your time zone from the drop down menu. Click
Apply to save settings.
Time setting using a NTP server
1. Click Enable NTP client update option to obtain date and time settings from a NTP
server.
2. Select one of the below options. Click Apply to save settings.
NTP Server: Select a NTP server to use.
Manual IP: Manually enter your NTP server.
2. You can also click Enable NTP client update option to obtain date and time settings
from a NTP server.
To Next Page
Loading...
Need help?
General
